Summary: Alternating Current and Measurement Technology
The following formulas were used in the chapters on alternating current and measurement technology:
AC Voltage
\[
\begin{gathered}
u(t) = \hat{u} \cdot \sin(\omega t + \varphi) \\[6pt]
i(t) = \hat{\imath} \cdot \sin(\omega t + \varphi) \\[6pt]
T = \frac{1}{f},\ [T] = \mathrm{s} \\[6pt]
f = \frac{1}{T},\ [f] = \mathrm{Hz} = \frac{1}{\mathrm{s}} \\[6pt]
\omega = 2\pi f = \frac{2\pi}{T} \\[6pt]
\varphi = -\frac{\Delta t}{T} \cdot 2\pi \\[10pt]
u_1(t) = \hat{u}_1 \cos(\omega t) = \hat{u}_1 \sin\left(\omega t + \frac{\pi}{2}\right) \longrightarrow \textbf{cos} \text{ leads } \textbf{sin} \text{ by } \pi/2
\end{gathered}
\]
Networks with Resistors
Resistor networks are calculated with the peak values just like with DC quantities:
\[
\begin{gathered}
\hat{\imath}_0 = \frac{\hat{u}_0}{R_{\mathrm{Ges}}} \\[6pt]
\hat{u}_1 = R_1 \cdot \hat{\imath}_0
\end{gathered}
\]
The Measurement Chain
Input voltage range of the ADC:
\[
U_{\mathrm{Ein,ADC}} = [0\,\mathrm{V} \ldots U_{\mathrm{Ref}}]
\]
Signal Flow Diagram and Block Diagram
\[
\begin{gathered}
H = \frac{\text{output signal}}{\text{input signal}} \\[6pt]
\text{Output signal} = H \cdot \text{input signal} \\[10pt]
H_{\mathrm{Ges}} = H_1 \cdot H_2 \cdot H_3 \\[6pt]
H_{\mathrm{Ges}} = H_S \cdot H_V \cdot H_{\mathrm{ADC}} \\[6pt]
\text{Number} = H_{\mathrm{Ges}} \cdot C
\end{gathered}
\]
The transfer functions of blocks connected in series are multiplied.